Yup, from what I've been reading everything says that error is a hardware error. Some suggested the RC was the culprit HDMI module installation issues.
I would say my phantom 3 Standard Was Way better than what I have now. Never had any issues other than at about 400 m video would disconnect but always fluid until that point
So I have a piece milled setup here and I'm looking for some insight. I have perfect video on the bird but what I get displayed from the RC is terrible. This is a P3A with GL300C and a P3P camera. I've tried custom Chanel settings and when I pick a specific Chanel it improves but it's never...
So I bought a used pcb with motors attached to it to put in a drone I bought second hand. (Should have just bought a good working drone but I'm a tinker Todd) I also bought a used camera that was "supposed to be working". Anyway I hooked the board up and connected it to my RC and everything was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.