didn't see this earlier, as time is very limited, but you can see plenty of the new setups now that they are being mounted.
:D
check us out on facebook too!
Tony.
You can remove the internals of the wifi extender and make holes with a small drill. I like battery powered vertical drills where you can control the speed and they are light and easy to handle.
You can make a smaller pilot hole and then enlarge it to 6mm or 1/4 "
guys, the only time an antenna would be damaged is if a lobe is pulled out, if you crash or step on them,
through normal use it's not possible.
Of course the sma plugs have a few hundred screw-unscrew cycles in them then they are not reliable any longer, but it can be quickly fixed by having a...
This guy purchased the antennas not from us but from Ebay,
and the ebay seller warned me about this guy lying.
I have the message he sent me a few days ago
"Hi Tony
I received the Stage 2 and installed it successfully this time!
I want to give you a heads up about a potential customer (if he...
Hi Guys we can perform the mods professionally ourselves but our prices are not the cheapest.
stage 2 install is 50$ (1 hour work)
stage 3 install is 150$ (4 hours work)
all power output levels are measured with a spectrum analyzer to make sure the install went well.
Tony.
Hi J, you are correct, things can be improved immensely.
I forgot what antennas you have at the moment.
To go further I suggest a 600mw ImmersionRC tx and a immersion duo Rx which is better than the built in receiver of your monitor.
You use the 4.25 turns helix on one port and a pinwheel on...
Hi, yes our 5.8ghz side has always been RHCP to differentiate it from the LHCP of the 2.4ghz, so you get best performance.
For control range issue the problem is 99% due to installation problems, when people cut the connector inside the transmitter so they have no ground connection, if you take...
Yes. you are correct, you can get a much better connection if a new hole is drilled in the top right side of the transmitter shell.
No question about that.
TOny.
sorry about what happened. the replacement was just sent out. I am thinking that it's possible the sidebox mount, being so slippery could cause antennas to unscrew if the female sma thread isn't long enough.
For this purpose we recommend using a 8mm wrench, Craftsman 42346 is one of them...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.