Recent content by johnbt

Re: Gimbal rolled to left, will not center using Assistant 2 No further progress to report. Multiple other things tried yesterday, so in lieu of a solution, this one goes back to Amazon and I will have a new one with one day shipping tomorrow to finish the shoot we are working on in Montana...

Re: Gimbal rolled to left, will not center using Assistant 2 Worked perfectly 1 day before. On a PC, but have a Mac available too. Redownloaded latest Win driver and Assistant 2.20, still does not connect. Thanks.

Re: Gimbal rolled to left, will not center using Assistant 2 The computer "sees" the P2V+ and the cable seems to be good because the computer chimes when the USB cable connected to the Vision is plugged into the computer. Tried powering up the quad before and after the software, no difference...

Re: Gimbal rolled to left, will not center using Assistant 2 Have tried multiple cables, and so far can't get the P2V+ to connect to the Assistant 2.0 software. Tried with controller on and controller off and still won't connect. Redownloaded Assistant, still wont connect.

Re: Gimbal rolled to left, will not center using Assistant 2 Took as carry on, but small plane required gate check. The case has potential for air seal, but I had the vent open to prevent pressure change issues. I'll try the advanced IMU calibration later today and report. Thanks everyone for...

Just flew on airline with my P2V+ in custom case with gimbal lock in place, gimbal not touching any object in the foam well of the case. On arrival, everything looked fine, but the gimbal lock was off the gimbal, suggesting to me that the case may have experienced a stong bump at some point...

As I began flying my 2V this morning, I noticed that I have no telemetry data displaying on my Android phone running the DPI app, while both FPV, photo and video functions remain completely intact. All firmware and DPI app are current. Gimbal works when the quad is held and tilted, but the...

If a previous answer appears, I apologize. I have installed the latest driver twice, even uninstalled it and reinstalled. Same with the Assistant software. I appreciate the suggestion about plugging USB directly into the P1's board and will try that tomorrow and report back. With no response...

Thanks very much for the replies. I will certainly apply the suggestions, but a challenge at the moment is that despite doing what I described in the initial post, the NavM Assistant software does not see the quad when connected via the USB cable on the quad. Once I can make that happen, I can...

I have a Phantom 1 that was flying well and then suddenly gave the error message "TX stick(s) mid point error too big" (4 red LED's) and would not restart. Tried recycling transmitter/controller and power to unit, problem persisted. Installed latest Win driver and assistant software. When...