Recent content by iCorp

Hello everyone, I wanted to share something that happened to me earlier today, I was flying at 120 m height the drone was just above us and when it was coming down I suddenly lost control of the aircraft and it just kept getting down and crashed on the floor. When I got there the battery was...

Hi there, just to let you know that replacing the center board did the job, the bird is up & flying again. Thank you quaddamage

Thank you for your reply, first of all, i didn't mean to appear in the pic :). So.... in other words i need to replace only the main board ??

Hello, i've tested the battery outside the bird and it's showwing 16.89V with the multimeter, i've tried with another battery from another phantom 3 and it is the same, when connected it powers off automatically after 4 o 5 seconds (now i'm sure the battery is not the problem). I've taken apart...

Well it seemed not complicated (in theory), just make the power clip and attach the secondary battery making sure it was the same type (4S). I'm pretty sure it was because of the conductor, was thinner than appropriated so it burned immediately. I know the cause what I'm looking for is a...

I forgot to mention, i was using one Turnigy Graphene Professional 5200mAh 4S 15C LiPoly Pack w/ XT60

I´ll keep you updated as soon as i get back home. I hope i can fix this by replacing the mainboard in the worse case.

This is what I was "trying" to do, followed all the instructions but as i mentioned before, the width of the power clip was thinner than the appropriate so... I´ll post pics as soon as i get back home, I´m traveling this week. Thanks for your time

Trying to improve

I´m trying to know if there is something that can be done to revive the bird, everything looks ok to the eye, cables, pcb, etc.. just not powering up (never loose hope)

Thank's for your tip, the battery is four leds on when powered. I f***d up the bird because of the clip I used, it was thinner than the appropriate width so it just burned when conducting. You can say "Pollito al horno" haha

Well, those cracks were made the day before the pic, i was trying to make a fly away shot, just crashed with a palm tree. Guess i am not ready for fpv

Hello everybody greetings from the center of the world Ecuador. This is my first post and any of your help will be very appreciated. I was trying to make the "Clip" battery modd to my phantom 3 standard and when I connected the two batteries it just burned as soon as they made contact, so I...