So I have a Can port on my Phantom 2 Vision V2 board. Just for fun I am connecting my GoPro3 for FPV.
Could I get an IOSD to work with the similar process to what you guys have done?
Its an old thread. I am just getting into it with a Phantom 2 Vision for practice.
Hi. I am hooking up my gopro for FPV flying. I want the flight data like you get from the mini iosd. However without the can bus I cant use it. Are there any other ways to do it. I dont need to log or anything Flytrex seems a bit expensive for the 3g anyway. They do have others but dont know...
Hi again. I do have the opportunity to get a hold of the upgraded controller. Phantom 2 vision plus with the thumb wheel. Does it work well without the issues of continual drive. Does it stop when you stop the wheel rotation. Thanks again.
Greg
All sorted.
I got in the Turnigy motors which are not as wide.
This in turn helped me to balance the gimbal with no power.
Before if flopped all over the place.
I had to modify the printed pitch arm a little to get the balance right.
Now I dont need to run any near as much power on the motors...
I have tried this with the china style gimbal motors.
No good all out of balance. Worked ok straight and level but topples with any major manouvers.
Worth a try. I have ordered recommended motors.
Just in case anyone else was considering doing the same.
Thanks again.
I will get a Phantom 4 or Mavic Pro one day so will save my money.
The P2V has been a great training drone. I have done gimbals and replaced motors after I stuck long screws into it. Yeah the prop guard screws. Glad it wasnt a new drone.
Through fear of bringing up a repeated topic I am going to after not really finding an answer. Or there being so much info I find it hard to sort out the exact help.
I am new to the forums and have found it a great source of information prior to joining.
Anyway I installed a 5k ohm linear pot...
Hi everyone.
I am new to the forums and own a P2V.
When I fly a way point flight and return to home I cant seem to go again unless I go to settings and reset ground station. Turn it on and off.
I go to set up some new way points and dont get the GO button enabled unless I reset ground station...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.