The new board fixed the problem, and I have been flying successfully.
I would love to use this as a spare board, but I'm unsure of the power transistor location. Has anyone else performed repairs to the main board, or possibly know of some good links for me to learn from?
Thanks again for all...
Perfect. Its nice to have confirmation on this, thank you.
I picked this P3A up used and non-operational about a month ago and have been slowly getting it all into working order.
I ordered a new board that "should" arrive on tuesday, so hopefully I will finally get to fly this thing.
Again...
BudWalker, I finally got a chance to look into the log information, thanks for the tutorial btw...
Would anyone be willing to break down what the log info means? I would hate to work on this thing as much as I have been, just to find out the correct fix is listed in the log.
I've had firmware...
I actually did swap out the opposite side motor and the beep didn't follow the motor. I ordered a new board today, so fingers crossed.
Sent from my 0PM92 using PhantomPilots mobile app
I ended up doing an rc reset, then removed and tested every last cable except the gimbal ribbon cable. Found plenty of pinch points and replaced those right off. Fired it all up and BOOM. It finished upgrading to 1.9, got it connected to the rc, everything looked great, then one of the motors...
I've been working with DatCon, but the dashware software isn't working for me. I open the zip and see no exe or application to install.
Sent from my 0PM92 using PhantomPilots mobile app
I have a P3A with one motor that sounds like it is beeping. When i turn that motor by hand, the volume changes.
I was schooled by Quaddamage:
"Motors and speakers are similar; you can use motor as speaker with some smart driving. This is why ESCs usually announce error states this way.
This...
I was afraid of that. So if a motor beeps, the ESC to that motor has failed, correct?
I went to the logs but had a tough time trying to figure out what to do with the .dat files. I was able to pull up a log that looks like a colored line jumping all over a map. The problem is the map is of my...
It was one of the cables. got the firmware fully updated, but now there is a beeping sound coming from one of the motors. and if i turn it slowly by hand the volume of the beep changes.
I switched motors with the opposite corner and both motors in the one location have the beeping sound. Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.