Recent content by Falcon2015

I have a P2 vision plus 3.0 with latest firmware. I purchased the aircraft second hand it did crash at one time. The compass tiny board on landing skid is exposed. I have re-calibrated IMU and compass. Aircraft takes compass calibration and locks to GPS. Fully charged batteries and tried...

WOW

Okay, after 8 weeks. DJI repaired my flight controller and Gimbal. They did not even want to speak with me about the loss of power, etc. I will not complain, even though it took a long time, they did fix it. It's on the way home now, and hope it flies well. I will admit that I have a...

Was your incident a complete loss of power at 165'?

Congrats!! I am in week 7 and they told me that DJI will replace, or repaired based on what the technician feels is appropriate. I cannot believe they have not set policy on replacement, or repairs. They leave it to the tech to decide. I guess I will cross my fingers and hope for the best .

Thank all for your replies. I do not feel so alone now. I just hope to get it repaired, or replaced and hope never to have another incident.

Since my Phantom 2 Vision plus fell from the sky 6 weeks ago, for power failure right after a fresh battery install, DJI has yet to contact me. I suspect it will be the last day of week 6 before I hear from them. They should have read my report and simply replaced the item being that is was...

That is great to hear. As long as they take care of me, I will have nothing but good to say.

My P-2 Vision plus 3.0 is at DJI as of Thursday. They say it can take up to 6 weeks in que. I sure hope that this is not the case. Much too long to make a determination if you are going to replace a customer's item, or not.

In my case its some type of intermittent battery failure sensing, which initiates a failure warning on the FPV monitor before complete loss of power. What is really strange is the P-2 appeared to fly okay and maintain hover immediately after the loss of power and crash. Needless to say, I...

I thought of the #2 csc, and should be corrected by DJI engineers, to have an addition toggle to throw prior to emergency csc. I have read this happening too much. In my case in was in a hover mode only after 58 seconds of flight, got a battery error, "not enough battery power to return home"...

When was your fatal crash? Did you have video for them of the crash?

vmp, can you PM, or contact me. I would like to talk to you on the phone. Did your P-3 crash what date? Thanks

Look like the same caused my P-2 to go down this week. The only difference was mine was hovering at 60' for 58 seconds when it got an error " Not enough battery power to return home". Seconds after loss of connection with P-2, loss of FPV video, and then straight down like a rock. I think DJI...

Lets just see what DJI does with CS? The video should help them determine it was not pilot error crashing into something. I cross my fingers on this one...for it will determine if I stay with DJI, or go 3DR next time.