2 motors are making a slight growling sound. Its not the props. Ive check out thoses videos and mine dont make that sound. And ive pulled up the springs to ensure that isnt the problem.
Top left and bottom left motors are affected. The one on the top is a little easies to hear. Any advice...
I want to cut 3 wires that go from esc to brushless motor. Then i will be soldering 3.5mm bullet connectors to each end of the wires. One end will get male the other femal. This way i can get the motors to disconnect from the drone itself to better change bearings or do complete motor...
Sorry for the confusion, i forgot to add a few major details. I wanted to put connectors on for the brushless motors seems as though 3.5 mm wont fit through the hole of the drones plastics the wires go through to get to the motor.
So ive heard of people putting on 3.5mm bullet connectors onto their p3 and other drones. My question is will this work for the p4 because the wires gp through a hole in the plastic so im not sure if the 3.5 mm would fit since it os woder on one end. Can anyone help me out?
Been wanting to get a full set of cermaic bearings since i believe that a few are worn. Anyone have experience with these? Also anyone have a link for good ones?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.