Recent content by doc_sus

Here it is! The TACT SWITCH, the image should answer any and all questions pertaining to this switch and its replacement. The switch itself is relatively small. I did not measure it as there is enough room to go with one even larger then the factory installed switch. I went a step further and...

JB63 that is my plan, to get the pin layout and get a replacement that will fit the blueprint. I will let you know what part number I end up going with. Thanks!

below are the images of my missing button. as @Multicoptertec mentioned, the led is next to the button and illuminates the clear housing that is pressed through the opening of the housing.

If anyone does have the mother board, would you mind doing a visual inspection of any part number on the button. Also, if its not too much, a few close up pictures of it to easily identy when looking for a suitable replacemeny. Thank you in advance!

The issue I am having is that my original remote is faulty. I couldn't fly more than 150 feet away without losing signal in a clear sight from me to the drone. Even going straight up from my location, I would lose signal. Thats what prompted me to get a new remote, and I did get rid of the old...

That I am not sure! I had purchased the phantom second hand. The condition was great and am not sure how it fell apart or broke. Do you have any idea what that part number might be? or the type of "button" that I need to quire as a replacement. Thanks!

This is what it looks like on the mother board. when i push nothing happens. Thats what prompted me to look further at the button. I took it alart and the button is not there. I didnt get the chance to take a pic of mine, but attached is what it ahould look like. I will providw an image later...

This is what I am referring to. Inside is a learn button to pair with the remote. Next to it is an LED that lights up red, as seen in the image, or green. I need to know what the part number would be for this button as mine is missing/broken. Id like to have it replaced by an electrician...

Hello all! I had issues with my original controller that came with my P3S and have gotten a replacement. As a result, during pairing mode, the button on the drone has to be pushed within the 60 seconds. I tried this several times with no luck. I then removed the battery to inspect the button...