Recent content by cuda

I did get what I thought was the correct board but its the board inside the remote control unit (Wifi download link module). I spoke with DJI parts people and you can only get the board I was after by purchasing the camera assy and gimble as 1 unit. So I decided to scrap the idea and purchase...

Maybe check the cable from the wifi download module to the camera as it is a flexing cable and can break. I can simulate loss of connection and reconnect by disconnecting the camera gimble cable.

S Standard from my understanding has 1 visible antenna and one power switch whereas the advanced and pro have two antenna and 2 push buttons. The Phantom standard 2.4Ghz module (metal cage is located slightly below the middle on the left) of the controller.

I new it had an issue but figured I would sort it myself.

Seems to be the case as the GPS is located in the other board on top of the P3S and not sure about RTH unless is was connected at time of initial takeoff. Info is stored onboard P3S and does not need connection to app as it will RTH when signal is lost for more than 3 seconds.

Ah ok. You have the RC which the phone connects to via the SSID. The RC connects to the P3S via the wifi download module. So if the wifi module is not working it will show full signal on your phones SSID but the RC will be red.

Yep done a test flight. Managed a full flight and the landed and lost connection on landing. Tried to take off again manual control and no problem P3S holds position even when not connected to 2.4Ghz ( no app data or camera) but I can control the gimble camera and it seems the camera is...

Thats what I thought until I completely disassembled the gimble and board. Without the camera connected to the board the RC would connect and disconnect repeatedly. So any issue with gimble flex cable to camera can cause connection issues to the app on mobile device and RC. However main p3s will...

I have turned all wifi off around the house so should be ok. Next door neighbour has one and does not have the issue.

If you disconnect the gimble cable and try to connect you can fly the p3s no problem but as its connected to the 5.8Ghz receiver but you cant communicate through the app as the 2.4Ghz repeatedly connects and reconnects. This is my understanding of the system as I am troubleshooting another issue...

Purchased a Phantom 3 standard second hand only to find that the Transmitter (controller) loses connection intermittently with the Heli, I have tried the latest firmware and it will lose connection when right next to the Heli. I can however still control all heli functions and the camera gimble...

This could be that your gimble camera is not connected properly to the Wifi download module. It could be that the flexible gimble camera cable has a partial break in it.