Sorry for dragging up an old post but I thought the end of this story may be of use to someone
In short, the dial did not work on the new (NDJ6) controller, would not tilt the H3-3D. Tried manual and software calibration. Tried various firmware and assistants. No luck, Brought it back to the...
Hi capodrone81,
Dealer did both a Phantom Assistant calibration and then a manual one. No RC Assistant, but I agree with you would and assume that it is the same as the manual method?
I had done similar at home but with no effect. Maybe the wind was blowing in the wrong direction or I was...
Just to close this off
Brought this back to the dealer and he plugged it into his iMac - did a calibration - did a manual calibration (just the controller, see below) and then it decides to work!
I had done the same a few times, so all I can say is that maybe a different machine helped! It...
Hi Mako79
Here it is
One other strange point to mention is that now on the Phantom Assistant landing screen the "Gimbal Switch is now OFF" - How do I turn it back ON?
And finally as in the video, regardless of my issues should the x1 cursor move in the RC Assistant when its plugged in using...
Again Thanks Mako!
Yes the h3d3 imu is 1.0.0.12.
Right now the gimbal turns on and just faces front or flat down. No response from dial.
http://youtu.be/oKyDH12B2uQ
I'm thinking the issue could be a hardware one related to the dial on the remote? In the RC Assistant, all the slides respond...
Hi Mako,
Yes all instructions followed - no change. The dial on the ndj6 has no effect in the RC or Phantom Assistant and in turn the gimbal.
Any other ideas welcome or is it rime to send back?
Thanks John
Thanks @Mako79 & dptcalvin
Even when I connect to the Phantom or RC assistants and move the dial the black arrow on the X1 range does not move. All the other controls work and I can see the arrows move on the range sliders.
The gimbal tilt does move when I click the REV toggle button and the...
Hi All
Have setup the Phantom 2 and H3-3D but unfortunately the gimbal dial on the new version of the remote is not responsive and does not control the tilt of the gimbal - it stays at 45 degrees.
I have tried to calibrate the x1 dial but not responding in RC or Phantom Assistant.
What am I...
Hi All,
I'm assuming that the motor has given up the ghost. When idling the motor (bottom right on the video) keeps stoping for a fraction of a second and then starts again.
http://youtu.be/FtvVN5ilWJQ
Is this a sign of the motor failing or something else?
Assuming is just this motor should...
I know the IAA contacted the chap who flew over Cork city.
http://www.eveningecho.ie/2014/08/25/bi ... view-cork/
*NOTE the caption on the last photo - they call the P2V+ a Predator II drone :)
Would be good to know if they are contacting other multi-rotor pilots?
The video is beautiful but...
Just to give a taste of how UAVs are portrayed in Ireland - here is a brief article from the Irish Times.
http://www.irishtimes.com/life-and-styl ... 523?page=2
Nothing new, the normal themes of regulation, safety and privacy are raised.
Corncrake
Hats or ties :lol:
Just saw this Mal...
[ ]
Speechless :shock:
I live near the towers, were you on a job or "research" - incredible footage - please take out the battery of that P2V and frame her on the wall.
Corncrake
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.