From what I've read some p1 have the dual antenna, while mine has a single antenna. I think that's where this issue is happening. (ppm vs d-bus style RX/TX) I can upgrade to the dual and the new tx should work otherwise I think I'm SOL. Fingers crossed something else comes up
I have tried that. I posted the steps I took in an earlier reply but essentially they are the steps in the DJI manual. After further researching I came upon the conclusion that I need either a new receiver, or a different tx. Hopefully I'm wrong though.
After searching around it appears I have two options.. either return the transmitter and replace it with an SR6 transmitter, or buy a new D-BUS receiver to match the new receiver.
If there are any other available options please let me know
Haha of course! I've had this bad boy for a long while. Finally decided to add the gimbal pitch control lever, and what do you know, I fried my dang TX. Bought this new one and its being a pain in the A to get it to work. I'm not even sure if you can still purchase the stock P1 Tx anymore. I...
Hey There!
It does have the red light inside. I've opened up the copter, pressed the little button that is supposed to link the TX, it starts blinking, I pull the throttle stick all the way down, then turn on the Tx and nothing happens.
I found those instructions from the DJI wiki page so...
Hey everyone,
I'm new around here and like most people I'm sure, I've joined because I'm having an issue.
I recently purchased this transmitter because I fried my old one...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.