No I was able to get the connector piece off and use it again to resolder back on the cable and then snap it back on but I think because the cable has a little mesh type insulator around it and when I soldered it back on that was also soldered to the cable it cause it not work work right.
-Chris
Wow that's impressive! That one is about twice the cost as some of the others but as long as it's serving you well that's all that matters I suppose.
-Chris
Hello all,
So the cable on the antenna where it plugs into the board pulled away from the connector. Tried to solder it back on but I think because of the shielding around the antenna wire I wasn't able to get it soldered properly and so I can only get about 200' away from my controller before...
Phoenix area? Looks like my stomping grounds [emoji3] I just got a P3S had to send it back because of a gimabal twitch. Got the new one and the video is so much better now.
As far as your pics I would agree with getting a polarizer too. That should help and edit in PS or Gimp
Sent from my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.