Recent content by 96vette

FS: Avegant Glyph Founders Edition headset, like new with all cables and accessories. $399 shipped (paypal or MO) located in Louisiana

Re: Zenmuse H3-3D Gimbal PM sent

It's probably a malfunctioning reciever. I had one go bad on my 2 for no apparent reason.

Yep, this one was mine. I've been helping him troubleshoot the problem, but so far nothing has working, for whatever reason his app will not allow manual control of the pitch even though the gimbal appears to be operating properly. I'm out of ideas

Try this: remove the cover from the gimbal control board and check the continuity of the blue wire is connected to the board, there could be break in the solder joint or the wire itself, also check to make sure the battery didn't pinch or damage the tilt control cable. It has to be a...

SOLD!

Reduced

no, this was just a one time thing for me, in fact it cost quite a bit more to build than what I'm asking. The 3D printing alone was over $200

I'm selling my MotorPixie design gimbal, I built. I just received a Gopro camera as a gift, so I decided to convert my vision to a gopro, zenmuse, FPV system. specs: 3D printed parts are Nylon and printed by Shapeways. Turnigy 2206-140kv brushless gimbal motors control board & IMU (from a...

Hi, I have a 5.8 Ghz transmitter, RE700 wifi module & 5.8 Ghz receiver $175 shipped

SOLD

affirmative

Sorry, if I gave you the impression I was looking to give these away. :roll:

https://www.youtube.com/watch?v=FrWPmtUsfLI I was finally able to get the quad up in the air this week while I was on vacation in the mountains of Boone,Nc. This was my first flight with the Motor Pixie design. unfortunately the LOS window was narrow but I think it performed well, It was...

$560 shipped