Hi,
I'm trying to install a Zenmuse H3-2D onto my Phantom v1.1.1 with the upgrade kit. The Phantom has the 8-pin flatcable connected to the motherboard. I've connected the 8-pin to the Zenmuse.
When I open up the Naza-M assistent it sees the P330CB-H3-2D with the lateste firmware (1.1.2.1). Also, the Naza itself has firmware v4.02. But it should also report the gimball IMU and CMU. It does not. Also, the gimball does not seem to have power.
I switched the Gimbal option in the Naza Assistent from Off to On, with the default values. I did a power cycle, but still no power to the gimball and it does not show up in the assistent
Am I missing something? Could it be my flatcable? I've never tested the cable with another Zenmuse, so I don't know if it's working. I DID test the Zenmuse on another Phantom. It does work there, so it must be something in my configuration or hardware.
Any thoughts?
I'm trying to install a Zenmuse H3-2D onto my Phantom v1.1.1 with the upgrade kit. The Phantom has the 8-pin flatcable connected to the motherboard. I've connected the 8-pin to the Zenmuse.
When I open up the Naza-M assistent it sees the P330CB-H3-2D with the lateste firmware (1.1.2.1). Also, the Naza itself has firmware v4.02. But it should also report the gimball IMU and CMU. It does not. Also, the gimball does not seem to have power.
I switched the Gimbal option in the Naza Assistent from Off to On, with the default values. I did a power cycle, but still no power to the gimball and it does not show up in the assistent
Am I missing something? Could it be my flatcable? I've never tested the cable with another Zenmuse, so I don't know if it's working. I DID test the Zenmuse on another Phantom. It does work there, so it must be something in my configuration or hardware.
Any thoughts?
