Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Zenmuse dying after a rough landing

Discussion in 'Zenmuse H3-2D GoPro Gimbal' started by ericty, Oct 10, 2013.

  1. ericty

    Joined:
    Oct 7, 2013
    Messages:
    163
    Likes Received:
    0
    Hello all - I had a rather rough landing where the Phantom bounced around a couple of times before stopping. End result was the 8-pin gimbal cable being pulled out with some of the plastic housing (at the plug end) disintegrating. Yes...I know...I am a newbie pilot. However, I replaced the 8-pin cable but the gimbal still doesn't activate when powering up the Phantom. Anyone else experience something like this? Is there a solution or is this gimbal now trashed?