Will the gimbal/camera still work if I use another gimbal controller board from another phantom + ?
Will it have to be re-binded again? The board I'm talking about is up inside the two flat aluminum plates where the pan motor is.
After replacing the ribbon cable....will I again need to re-bind the camera/gimbal?
Also does anyone know where I can get the gimbal control board???
Your knowledge is very appreciated!
Will it have to be re-binded again? The board I'm talking about is up inside the two flat aluminum plates where the pan motor is.
After replacing the ribbon cable....will I again need to re-bind the camera/gimbal?
Also does anyone know where I can get the gimbal control board???
Your knowledge is very appreciated!