Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Tx wont respond after adding tilt lever

Discussion in 'Phantom 1 Discussion' started by Moskino, May 8, 2014.

  1. Moskino

    Joined:
    Apr 14, 2014
    Messages:
    32
    Likes Received:
    1
    So after a stressful situation with the h3-2d, which is now working with my Phantom 1, now the transmitter not responding after taking apart and adding tilt lever that came with upgrade board kit..when i load up naza assistant 2.20 it recognizes the receiver..shows mode failsafe. but the sticks indicator are black and all the way to right..receiver type set to d-bus..i made sure tx is bind to the receiver..made sure no wires in tx loose..i calibrated the tx..getting error 27 gps not calibrated.Desperate to get back in the air..Any help is greatly appreciated.
     
Loading...
Similar Threads - wont respond adding Forum Date
Standard FW wont update Phantom 3 Help Yesterday at 8:12 PM
P3 Firmware This pig wont fly Firmware Jun 8, 2017
**VIDEO** ANY IDEAS WHY IT WONT HOVER STABLE?? Standard/4k Discussion May 28, 2017
Standard new laptop wont recognize 32G SD card ? Phantom 3 Help May 28, 2017
DJI Goggles arrived but wont activate on P4 - Activated now by using a Mavic DJI Goggles May 19, 2017