tilt control lever and LED V2

[jpz]

yesterday I've done the dirty job of assembling the zenmuse to my phantom, I've done a first test flight and it's amazing 2.7k at 30fps absolutely steady.
just a couple of questions.
my seller sent me the LED V2.. what can I do with it?

what lever are you using for tilt control? I've seen there are 2 on shapeways, I'm concerned about the quality of plastic, is it safe with heavy use? turning the knob inside the controller is quite hard.

 

[boat chaser]

Check out these links for a trusted easy to install. Excellent control. I marked a 0, 45 and 90 degree angle on my TX.
http://youtu.be/r9DFf2ZY8S0


http://youtu.be/4hStYq2vatM

this one is the one I used. make sure you wire it correctly, it is very simple. I'm no electronics tech i'm run a painting company. If I can do it anyone can.

 

[jpz]

wow never seen that before, looks very clean and marking the exact angles is very important for me.
thank you!

 

[boat chaser]

Glad to help, this forum is very supportive, I flew it today on 2.7k sunset OMG stability!!!!!! and awesome control thanks to the $5 install. Stoked.