I have 2 P3P 4k Camera units that were damaged in a crash. The usual damage was present, broken roll or yaw arm and broker ribbon cable.
I have repaired the physical damage using 3D printed parts, and I must say am very impressed with the parts quality and fit.
So now that the cameras are repaired, I would like to test them, however if I plug the camera into my bird and the camera has an electrical issue, can it damage my bird?
Also will it mess up any of the installed firmware.
Thanks!
I have repaired the physical damage using 3D printed parts, and I must say am very impressed with the parts quality and fit.
So now that the cameras are repaired, I would like to test them, however if I plug the camera into my bird and the camera has an electrical issue, can it damage my bird?
Also will it mess up any of the installed firmware.
Thanks!