Hello everyone! I have had my Phantom 2 for a while now and have not flown it very much at all. The other day I brought it out to shoot some video at work and immediately ran into problems. I did my pre-flight, calibration, etc. Then turned the props on and noticed a skipping motor while all the others were turning fine. I then noticed that 2 of the LED's were not lighting up either... I thought I would replace the motor, but that probably does not have anything to do with the LED's right? ESC? Both ESC's? Why would one bad ESC cause both LED's to go out? HElp!! I need to shoot this video and am at a stopping point until I figure out what is going on!