Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

RC Calibration Issue

Discussion in 'Pro/Adv Discussion' started by Paul A Byers, Sep 26, 2016.

  1. Paul A Byers

    Joined:
    Jul 29, 2016
    Messages:
    156
    Likes Received:
    23
    I installed the Itelite DBS02 on my P3P. When I turn on the remote it continuously beeps with a blinking red light. I have learned that the remote is telling me it needs to be calibrated. When I attempt this it says to move both sticks in all directions several times. When you do this it shows the travel of the the stick in each direction in % 0 to 100%. At first the left stick will not register any travel, but after several movements it starts to register. Then it tells you to roll the left wheel (camera control) in both directions. The left wheel will not register any value as if it is not working. When calibration is complete it is supposed to give you a finish button. This never appears. Therefore calibration fails. I can link the rc to the aircraft. When I enter calibration mode the beeping stops. However, since calibration never really is successful whenever I turn the remote off and on again the beeping continues. Any suggestions?

    Sent from my SAMSUNG-SM-N910A using PhantomPilots mobile app
     
  2. DennyBoBenny

    Joined:
    Aug 24, 2015
    Messages:
    127
    Likes Received:
    31
    Open the RC and inspect it for damage or loose connections or ribbon cables.
     
  3. Paul A Byers

    Joined:
    Jul 29, 2016
    Messages:
    156
    Likes Received:
    23
    I did that, I see no damage and no ribbon cables disconnected. I was extremely careful doing the install. Even wore a wriststrap.

    Sent from my SAMSUNG-SM-N910A using PhantomPilots mobile app