PSA connected with remote and Go app but wont move

[zelius92]

I just got my phantom 3 advanced. I just finished updating the firmware, calibrating the compass, and connected it to the remote. and its connected fine. But when i try to make it fly. it doesn't move. it doesn't do anything.

 

[alokbhargava]

"It doesn't do anything" what does it mean? Did you start the motors first ? Are you getting any messages?

 

[zelius92]

"It doesn't do anything" what does it mean? Did you start the motors first ?

Sorry for not being clear. I tried pushing the left stick forward to start the motors but nothing. IS there a way to start them

 

[alokbhargava]

Oh yes, you got to move both the sticks down close to each other to start the motors first. Once motors start, pushing left stick up will fly it up.

I suggest you to read the quick start guide again. Don't be in haste to fly it up.

You need to set many other settings too for safe return.

 

[alokbhargava]

Also watch DJI videos before taking it off.

 

[alokbhargava]

If you do not know how to start, how would you safely get it down and stop motors?

 

[zelius92]

Oh yes, you got to move both the sticks down close to each other to start the motors first. Once motors start, pushing left stick up will fly it up.

I suggest you to read the quick start guide again. Don't be in haste to fly it up.

You need to set many other settings too for safe return.

Thanks a lot!!

 

[Oso]

Please take the good advice of @alokbhargava and do not fly in haste. Please learn about your aircraft first. Please.