Hi,
I´ve just purchased a Dji Zenmuse H3-2d, I followed every instructions precisely to install it. Use PMU v2, but when I replace the X3 channel by the PMU v2 cable as instructed, I get a BEEP...BEEP...BEEP...BEEP...BEEP.. and it doesn't stop. If I replace the PMU v2 cable by the original cable that was in X3 channel, the BEEP stops, and it powers up normally.
Could you please help me with this issue?
I´ve just purchased a Dji Zenmuse H3-2d, I followed every instructions precisely to install it. Use PMU v2, but when I replace the X3 channel by the PMU v2 cable as instructed, I get a BEEP...BEEP...BEEP...BEEP...BEEP.. and it doesn't stop. If I replace the PMU v2 cable by the original cable that was in X3 channel, the BEEP stops, and it powers up normally.
Could you please help me with this issue?
