Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Phantom2 + H3-3D Power Filter Board

Discussion in 'General Discussion' started by Jbrown83, Apr 10, 2014.

  1. Jbrown83

    Joined:
    Feb 8, 2014
    Messages:
    51
    Likes Received:
    0
    I saw someone post this. Apparently it's some sort of interference filter of some kind for Phantom 2?? Think its free from dji to ones who just bought P2 H3 package, but I don't know where you get it. Anyone know about this? Does it come in the newest P2 already?(one with modified belly for zenmuse H3 3D) Where to get etc? Thanks for any insight!
     

    Attached Files:

  2. OI Photography

    Joined:
    Sep 23, 2013
    Messages:
    5,542
    Likes Received:
    17
    Location:
    Clarksville, TN
    I've never seen or heard of it before, but after looking at that pic I'm guessing it's a filter that goes in-line with the power/control/video feed to the new gimbal on the P2V+

    Could also be for existing models of the Phantom, many use that same 8-pin bus for the Zenmuse.
     
  3. FASTFJR

    Joined:
    Nov 7, 2013
    Messages:
    1,202
    Likes Received:
    169
    Location:
    South East PA
    I wish someone would post the DJI link about it, I can't find anything.
     
  4. Anticipate

    Joined:
    Dec 11, 2013
    Messages:
    35
    Likes Received:
    0
    They posted in the RC groups forum. It is to remove interference on the FPV feed. I have a lot of that very interference with this gimbal, so this makes sense. It does not remove Jell-O, DJI maintains that is a stability issue because of a number of factors including the dampening selection and improper installation of washers, and so forth.

    Some people are reporting that after the installation of the board, which DJI will provide for free for every person who already bought the gimbal, removes the Jell-O. But if you look carefully, it's definitely still there.

    personally, I only see the Jell-O when flying at full throttle.