Would my Tenergy TB6B CHARGER do a better job charging my stock batteries 11.1 2200 ma than the stock charger...if so, why. I have a small Capacity Controller to check my batteries. When fully charged all cells are close but after flying down the pack, the percentage rate of each cell varies a lot....one cell may be 14%, another may read 28%, the third may read 40%......maybe not in that order though. Is it a good to have the TB6B to discharge the pack once in a while? When I use the stock charger, it is set to 3 amp. Is that ok for a 2200 ma pack?
