Hey guys I got a used p4 on trade that had been crashed. It lost a prop at 150 feet fell into a telephone pole then the concrete 3 motors were frozen the body was trashed the gimbal yaw arm was broken off and the 32 pin cable ripped off with it.
I replaced the body the motors the arm and the cable and have it flying again.
The problem now is when I fire it up I'm getting several errors. Left vision sensor right vision sensor vision system and camera sensor.
When I did the cable I did mess up the black locking tab on the top board of the camera the last stop on the cable snapped one side of the tab so I just wedged the cable in there I think that's my problem there.
As for the vision system im at a loss.
I was hoping someone could tell me were I could get the board for the camera without having to replace the whole thing and what to look at for the vision system.
Thanks guys.
I replaced the body the motors the arm and the cable and have it flying again.
The problem now is when I fire it up I'm getting several errors. Left vision sensor right vision sensor vision system and camera sensor.
When I did the cable I did mess up the black locking tab on the top board of the camera the last stop on the cable snapped one side of the tab so I just wedged the cable in there I think that's my problem there.
As for the vision system im at a loss.
I was hoping someone could tell me were I could get the board for the camera without having to replace the whole thing and what to look at for the vision system.
Thanks guys.