Hello all, I hate for my first post to be a question but i've not got very far searching. I have a P2v+ v3 all firmware is up to date and this is my first flight since i've switched to naza mode. I have flown with the dji vision app on my iPhone6 around a dozen times (phantom mode) but decided to try out my new iPad mini and mount today. As a land surveyor i am interested in mapping so i decided to see if i can fumble through the Pix4d app to create an orthomosaic. I was not able to get any backgound mapa data to load, or very much i should say. Then i noticed the camera was showing a black screen. Gimbal control checked out fine but no video signal. The app overall seemed to function poorly. After a seriese of restarting everything i tried the Vision app. I was able to take off but noticed there was around a 10 sec delay in the video feed. Finding repeatable issues across the new device i once again powered down and restarted with my iPhone 6. Both the Vision app and Pix4d app functioned very well. Has anyone encountered either of these problems with their iPad mini?