Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

osd mini help needed - need a live person to work with

Discussion in 'Phantom 2 Help' started by Suwaneeguy, Jun 4, 2014.

  1. Suwaneeguy

    Joined:
    Feb 19, 2014
    Messages:
    701
    Likes Received:
    22
    I am slowly going insane trying to get OSD to work.
    What I need is a live person to talk to, in person, showing me how to do this.
    What I have:
    P2 avl58 tx iosd mini with fpv hub zeneuse h3-2d gimbal.
    Boscam LCD5802 7" monitor.

    The mini is connected to the hub via 4 pin plug and to canbus connector on the leg.
    I have the latest assistant software.

    Controller on, camera on, bird on.
    Monitor receives signal from camera just fine.

    Run the software. Make changtes, click "write".

    The little green light on the mini blinks rapidly.
    After I click "write" there is no response.
    Nothing says that what I have done is finished.
    There are no changes on the monitor.

    If you live in the Orlando Florida area, we could meet somewhere and maybe you can figure out what is wrong.

    Please don't mention graves RC. BTDT.
     
  2. xgeek

    Joined:
    Jan 20, 2014
    Messages:
    543
    Likes Received:
    0
    Location:
    London, UK, Declination -1.2
    Take a photo of the FPV hub so we can see how you have it connected please.

    You should have 4 cables plugged into the hub?

    1) Zenmuse gimbal to hub
    2) P2 to hub
    3) iOSD to hub
    4) Video tx to hub
    5) Switch should be in the iOSD position
     

    Attached Files:

  3. Suwaneeguy

    Joined:
    Feb 19, 2014
    Messages:
    701
    Likes Received:
    22
    Thanks.
    It was the switch.
    Once I moved the switch, the information shows on the screen.