No live feed after crash/camera won't center

[AgentCar]

I crashed my P3S after a gust of wind blew it into a house. Landed directly on topside from about 12 feet. Now I can't get a live feed or any information from the bird on the DJI GO app, but I can fly it. No lose in any controls. And also can still pan the camera up, down, left, and right. The camera and gimbal stay off center, even after power on and it does its "warm up, roll through" motions. I've tried re-connecting the controller, but can't get it to say it did, even though it will still control everything. From reading, I'm thinking it's the wifi module. But I can't find any clear answers. Any advice? I have taken to top shell off already in prep for possible parts replacement. But advice would be greatly appreciated.


Sent from my iPhone using PhantomPilots

 

[Webdevoman]

Did you ever find out the issue?

I have a similar problem with mine, my controller connects to the aircraft but I get no live feed and this was after a crash also.

 

[AgentCar]

Did you ever find out the issue?

I have a similar problem with mine, my controller connects to the aircraft but I get no live feed and this was after a crash also.

No, I'm still working on it. I've replaced the wifi cable (gray 4 or 5 pin connector on top of gimbal) and both antennas. Still no flying. I'm dwindling it down to the board on top of the gimbal that transmits wifi signal. About to buy a used, serviceable camera and try it out. I'll let you know if that resolves it


Sent from my iPhone using PhantomPilots

 

[Webdevoman]

No, I'm still working on it. I've replaced the wifi cable (gray 4 or 5 pin connector on top of gimbal) and both antennas. Still no flying. I'm dwindling it down to the board on top of the gimbal that transmits wifi signal. About to buy a used, serviceable camera and try it out. I'll let you know if that resolves it


Sent from my iPhone using PhantomPilots

Best of luck..

I ended up buying a whole new camera/gimbal for mine... Ouch is all I can say.