Separate names with a comma.
Sign up for a weekly email of the latest drone news & information
Discussion in 'Phantom 2 Vision + Discussion' started by 200V, Jul 14, 2016.
I bought a crashed P2+ (at a good deal, I hope) that has a number of minor issues. Solved.
I found one high enough resolution photo. It shows the following:
1332A6 (or 1332A5)
So this appears to be an inductor, 20% at 100khz tolerance. It's available at ARROW (I have connections...)
Can anyone confirm this ? Thx
If above info from 200v is not sufficient, try to tell us more: I have schematics, I have PCB board layouts, etc.. NO main board in any of our P2V3+ units match your pictures! There is NO big round thing on anything in our P2V3+ units that I recall....
Perhaps if you want confirmation, you should put a picture of the whole board you are concerned with here? My main board has a wireless module on it, but nothing big and round as you show as I can recall...
The round thing is the GPS board, just shown for reference on how hard it landed.
Look at the top 2 photos, on the black main PCB you'll see a missing component, that went between to 2 large, silver, horizontal rectangles.
the pcb layout and component layout is on this site somewhere.... here is some info...
it is indeed an inductor, marked 6.8uH....
If it was mine, I would put a jumper wire across it and see if the rest of the drone worked; a 6uH inductor is small enough to not be required for test purposes....