- Joined
- Dec 26, 2013
- Messages
- 52
- Reaction score
- 0
NEW PROBLEM! When upgrading my Zenmuse gimble firmware it disappeared off the list of firmware and is not completely un-responsive. 1/2 way through the firmware upgrade it said it failed and to power cycle the copter... It wont level or respond to the TX. just a limp noodle that powers my GoPro... I reloaded the main controller software and it popped back up in the assistant software but during the upgrade it said it failed and to power cycle. never seen it back on the assistance since.
only flow with it 2 times...
only flow with it 2 times...