Sorry, don't know how else to help. If you want to mail me your phantom I can look at it, but that's about all I can offer... 
iOSD or Immersion RC 5.8 FAIL?
- Thread starter scooter339
- Start date
Thanks for the offer. Do you think the VTX has burnt out. The antenna has always been connected.
It means it has power at least... Are you able to take a picture of all aspects of the connections and install?
I'm just not convinced yet that it's correct.
I'm just not convinced yet that it's correct.
mine gets hot also. I know I don't want to touch it. It also got hot enough to allow the stick of velcro to come undone. So now I don't leave it suspended by adhesion.
Studying it now... While I am looking it over, I'm going to ask the KISS questions...
Are you 100% sure the camera is powered on?
Are you 100% sure the camera is seated properly in the gimbal?
Is the gimbal stabilizing? (i.e. does it have power?
Did you test continuity from end to end of all the wires?
Can you take a picture of the IOSD plugged into the canbus?
Can you take a picture of the Gimbal connections and the vtx connections?
Are you 100% sure the camera is powered on?
Are you 100% sure the camera is seated properly in the gimbal?
Is the gimbal stabilizing? (i.e. does it have power?
Did you test continuity from end to end of all the wires?
Can you take a picture of the IOSD plugged into the canbus?
Can you take a picture of the Gimbal connections and the vtx connections?
From what I can tell from that picture and tracing all the wires, it "appears" to be correct. I'm at a loss... :?
LOL, that's why I asked! haha
No kidding, 4 days ago, I recieved a text message from someone and said, "got it, the camera wasn't seated all the way"
This was after 2 days of asking the simple questions...
Glad it's working!!!
No kidding, 4 days ago, I recieved a text message from someone and said, "got it, the camera wasn't seated all the way"
This was after 2 days of asking the simple questions...
Glad it's working!!!
Similar threads
