Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Internal Cable Pinch

Discussion in 'Phantom 2 Vision + Discussion' started by unity, Sep 8, 2014.

  1. unity

    Joined:
    Sep 8, 2014
    Messages:
    36
    Likes Received:
    0
    Anyone else have this issue? Might be worth a look. I am not sure what the cable is exactly for, but I noticed my battery needs a little extra push to install. When I looked inside I noticed some wires of the ribbon were flattened out. After the first few flights, it got worse but does not appear to be getting any worse now with a few dozen flights. My only concern is a longevity issue. I worry that over time it could wear through. I contacted DJI but all they did was close the ticket. I cant even rate my "experience" via a feedback email since its closed.
     

    Attached Files:

  2. mickey78

    Joined:
    Aug 11, 2014
    Messages:
    69
    Likes Received:
    0
    I'm looking at mine, I can see the place you are talking about but mine doesn't seem to be interfering... The placement seems about right
     
  3. Meta4

    Meta4 Moderator
    Staff Member

    Joined:
    Jan 8, 2014
    Messages:
    7,729
    Likes Received:
    3,448
    My P2+ gimbal cables at the front of the battery compartment were getting pinched and affecting the gimbal operation.
    Had to replace them and make sure the new ones are clear of the battery.