I have noticed, after updating to Assistant firmware 3.6, firmware 3.08 and zenmuse firmware 184.108.40.206, that the horizontal level of my gimbal gets tilted during manuevering. The gimbal is perfectly level at start up and at first during flying. Then it gets tilted, then it levels. But it is slow... 30 seconds or so to level out sometimes. It seems to happen when yawing. I checked and rechecked the FPV button in the app and made sure it was off. I'm not in FPV mode. Performed advanced IMU calibration. Compass calibrated. Any thoughts? Is this an effect of the zenmuse 220.127.116.11 firmware? This firmware update blows. Between the tilt control lever issue and now this, I wish DJI would make 18.104.22.168 available again. My email seems to have fell on deaf ears.