Hi. I have installed H3-3D on Phantom 1 without upgrade board.
I was installed it with PMU v2 + GCU - standalone version of H3-3D
But there is no chance to change the tilt speed.
The tilt of H3-3D is going 1:1 to the finger and this is unusable. DJI does not resolve this problem with the gimbal assistant..the peoples solve this with the other Rx/Tx and the servo speed settings.
I have questions > if somebody has the P1 with the P1 upgrade desk for H3-2D and H3-3D installed > how work the tilt speed in this config?
I was installed it with PMU v2 + GCU - standalone version of H3-3D
But there is no chance to change the tilt speed.
The tilt of H3-3D is going 1:1 to the finger and this is unusable. DJI does not resolve this problem with the gimbal assistant..the peoples solve this with the other Rx/Tx and the servo speed settings.
I have questions > if somebody has the P1 with the P1 upgrade desk for H3-2D and H3-3D installed > how work the tilt speed in this config?
