Hi guys,
so I recently purchased a phantom 2 with H3 3D gimbal. Had to update the firmware because the gimbal oscillating by itself. After update the gimbal was dead so I did the tweezer trick on the plate where the go pro goes and re-updated and was fine.
BUT it still moves up slightly by itself and gets hot.
https://www.youtube.com/watch?v=ismt_Ez ... e=youtu.be
I have also tried calibrating the x1 on the Phantom 2 software but also failed.
I have had a few minor bumps but nothing too bad.
Any suggestions?
JP
so I recently purchased a phantom 2 with H3 3D gimbal. Had to update the firmware because the gimbal oscillating by itself. After update the gimbal was dead so I did the tweezer trick on the plate where the go pro goes and re-updated and was fine.
BUT it still moves up slightly by itself and gets hot.
https://www.youtube.com/watch?v=ismt_Ez ... e=youtu.be
I have also tried calibrating the x1 on the Phantom 2 software but also failed.
I have had a few minor bumps but nothing too bad.
Any suggestions?
JP