H3 3D and Gopro 4

[koukou99]

Hello everyone,

Thank you to the active contributors for helping beginers like me !

I tried to put my Go Pro Hero 4 (Black) on the Phantom 2 Zenmuse H3-3D.
But after the initilisation, the camera lens points the floor and I can't control it with my transmitter.

Here is the video :
http://youtu.be/5Ua3dWAMmBs

Do you have any idea where the problem comes from ?

Thank you very much !

All the best,

François

 

[Gilbert Gomes]

Turn the controller on. Immediate flashing yellow indicates no TX signal. Page 10 of the manual

Use the lever on the back of the controller to change the tilt angle once you turn it on.

 

[koukou99]

Thank you Gilbert for your message.
I did the compass calibration. The lights are green, the drone flies, but the camera is still looking at the floor.
The lever on the back of the controller doesn't respond...

Can someone help ?

Would you like another video ?

Thank you again !

 

[koukou99]

I made a video to show you the transmition is working good, the lights are green...
http://youtu.be/KHC42XRPV0Q

BUT :
- the lense camera is pointing to the ground.
- the gimbal doen't move when I move the lever on the back of the controller.

Did I miss something ?
Someone can help ?

Thank you !