Good morning forum,
I recently crashed my P3A and it broke the Yaw arm on it's way down. I replaced the Yaw arm but now when I turn on the drone the Roll axis won't balance out. I can still control the camera pivot up and down from the remote, however the gimble won't balanced out and even during a calibration the gimble "ticks" and won't line up properly. Could this be a ribbon issue? Or something worse? I'm sorry I'm not too familiar with the gimble, I called DJI tech and they said they can't help over the phone. They want me to send the drone in, I'm trying to avoid that at this point. Thanks in advance for any and all help / advice.
I recently crashed my P3A and it broke the Yaw arm on it's way down. I replaced the Yaw arm but now when I turn on the drone the Roll axis won't balance out. I can still control the camera pivot up and down from the remote, however the gimble won't balanced out and even during a calibration the gimble "ticks" and won't line up properly. Could this be a ribbon issue? Or something worse? I'm sorry I'm not too familiar with the gimble, I called DJI tech and they said they can't help over the phone. They want me to send the drone in, I'm trying to avoid that at this point. Thanks in advance for any and all help / advice.