Gimbal calibration after repair

[massimoo]

Hello fellow pilots!

I just changed my ribbon cable after it snapped off in transport.

When Phantom is started it looks like something is off with the calibration. It doesn't find a correct position in right/left direction. Does anyone know where to adjust this?

Cheers!

 

[RoyVa]

It's acting as though one of the tabs on the ribbon cable is not all the way in the snap plugs. May have to check them. Don't know which one thought.

 

[GISTUPID]

That sound about right but BE CAREFUL!

 

[hunch]

massimoo,
when you put the camera part back and used one screw to tighten it in to the shaft did you put it in through half moon on that shaft or flat half?
is it a V2 or V3 gimbal?