FPV monitor signal not clear

[rovingtek]

Hello,
I'm reaching out to all the experts out there for help!!
I just finished my FPV setup on my Phantom 2 -Zenmuse H3 3D -Go Pro Hero 3 + Black edition with the following..
-DJI IOSD mini
-DJI ALV58 Lite
-FPV Hub
-Lilliput 664/W FPV monitor

Prior to this I had already installed the interference board internally.( should I remove this board now that I have the above installed)
In any event, I took it for a test flight to find out that the signal/image has ghost lines like an old TV out of tune. Does anyone have an idea what could cause this?

Any advise will be greatly appreciated
Thank You

 

[RCRookie]

Hello,
I'm reaching out to all the experts out there for help!!
I just finished my FPV setup on my Phantom 2 -Zenmuse H3 3D -Go Pro Hero 3 + Black edition with the following..
-DJI IOSD mini
-DJI ALV58 Lite
-FPV Hub
-Lilliput 664/W FPV monitor

Prior to this I had already installed the interference board internally.( should I remove this board now that I have the above installed)
In any event, I took it for a test flight to find out that the signal/image has ghost lines like an old TV out of tune. Does anyone have an idea what could cause this?

Any advise will be greatly appreciated
Thank You

You should post this in the Phantom 2 forum... Not Vision.

 

[Flying High]

Check both the Gopro and monitor are both set to the same system, either NTSC or PAL