Guys,
I am currently installing EZOSD, FPV (Fatshark Attitude V2) and Gimbal on my 1.1.1
I bought a carbon fiber mounting plate from ebay and mounted the VTX and OSD GPS module there and looks neat, so to keep things neat and clean I went ahead and placed the EZOSD current sensor inside the phantom right next to the NAZA controller and the FPV current filter just by one of the ESC boards (away from the RX). It really looks clean this way.
My question is: Would the current sensor and FPV filter interfere with the NAZA or the RX? the Fatshark manual says to install this as away as possible from the RX but I assume they refer to the VTX?
I can always bring these 2 modules to the outside of the Phantom but I hate cluttered and really managed to keep it nice and neat.
What do you guys think? Would this create an interference problem?
I am currently installing EZOSD, FPV (Fatshark Attitude V2) and Gimbal on my 1.1.1
I bought a carbon fiber mounting plate from ebay and mounted the VTX and OSD GPS module there and looks neat, so to keep things neat and clean I went ahead and placed the EZOSD current sensor inside the phantom right next to the NAZA controller and the FPV current filter just by one of the ESC boards (away from the RX). It really looks clean this way.
My question is: Would the current sensor and FPV filter interfere with the NAZA or the RX? the Fatshark manual says to install this as away as possible from the RX but I assume they refer to the VTX?
I can always bring these 2 modules to the outside of the Phantom but I hate cluttered and really managed to keep it nice and neat.
What do you guys think? Would this create an interference problem?
