Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

ESC error related to firmware update P3

Discussion in 'Pro/Adv Discussion' started by moonshot, Jan 12, 2016.

  1. moonshot

    Joined:
    Jan 12, 2016
    Messages:
    1
    Likes Received:
    0
    the P3 initialization would not permit launch when a update firmware popped up.
    the required firmware was loaded and the initialization verified and proceed to the launch. but then a new error ESC error appeared.
    the firmware has been reloaded
    a new board has been installed
    motors replaced
    wire harness replaced

    it appears as though the required firmware forced an update to incorporate the restricted airspace. the firmware does not allow returning to earlier versions of firmware.

    any ideas? can the firmware be reset and allow to begin for start processing the earlier firmware until the latest version of firmware is loaded
     
  2. Iflynaza

    Joined:
    Apr 11, 2016
    Messages:
    7
    Likes Received:
    0
    Location:
    England UK
    Thanks for taking an interest.
    The first pic shaows the dirt on gimbal rubbers, second pic grubby grips on tx, third pic something grey and sticky on the tx on off button

    image.jpeg image.jpeg image.jpeg
     
  3. Iflynaza

    Joined:
    Apr 11, 2016
    Messages:
    7
    Likes Received:
    0
    Location:
    England UK
  4. Iflynaza

    Joined:
    Apr 11, 2016
    Messages:
    7
    Likes Received:
    0
    Location:
    England UK
    Sorry moonshot I am new to posting and have managed to post on your thread not my own please delete my post thanks.