Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

cannot connect to dji assistant and "throttle t" indicate -1000

Discussion in 'General Discussion' started by mr hallnick, Apr 18, 2015.

  1. mr hallnick

    Joined:
    Apr 18, 2015
    Messages:
    2
    Likes Received:
    1
    i uploaded the driver installer, dji assistant & rc. i was able to connect to rc & calibrated the mc. i may have connected to dji assistant bcuz the 2 lights located in the lower left corner were lit AND all the throttles were at "0", except throttle t which indicated -1000. however when i rotated both controls the indicators do not move.

    i was flying yesterday without incident & all of a sudden this occurs. i found a video online instructing me on calibrating both the mc & the mc to the phantom. i'm 1/2 way there but now i'm stuck.
     
  2. Mako79

    Joined:
    May 16, 2014
    Messages:
    3,410
    Likes Received:
    567
    Location:
    Sydney Australia
    Do RC12 first. Plug controller into usb and calibrate and also move the x1 tilt dial. Close RC12.

    Then plug usb into phantom and calibrate again.
     
  3. CityZen

    Joined:
    Oct 22, 2014
    Messages:
    940
    Likes Received:
    36
    Location:
    NYC
    Is this a P1 or P2? For a P1, click on the Naza Assistant's Basic/RC page and make sure you have the right receiver type selected.