Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Anti interference board with H3-3D and P2 V3?

Discussion in 'Phantom 2 Discussion' started by uscpsycho, Apr 18, 2015.

  1. uscpsycho

    Joined:
    Apr 30, 2014
    Messages:
    50
    Likes Received:
    0
    I am putting the original H3 3D gimbal that required an anti interference board on a Phantom 2 V3.

    Do I stil6need to use the anti interference board? Does the V3 have a spot to install the board?

    Thanks!
     
  2. jason

    Joined:
    Oct 12, 2014
    Messages:
    4,113
    Likes Received:
    405
    Location:
    Commerce Twp,MI
    The interference isn't going to change just because you put the gimbal on a new P2. You can mount it the same way you had it on the other unit.
     
  3. uscpsycho

    Joined:
    Apr 30, 2014
    Messages:
    50
    Likes Received:
    0
    Thanks. There are some improvements to the V3. I thought maybe they might have built the anti interference into V3.

    I don't think there are a whole lot if these gimbals out there which require the board so the latest circuit board may not have been designed with a place to attach the anti interference board.

    I figured I'd need it but better ask and be safe than sorry.
     
  4. jason

    Joined:
    Oct 12, 2014
    Messages:
    4,113
    Likes Received:
    405
    Location:
    Commerce Twp,MI
    None of the P2 non vision zenmuse H3-3D/H4-3D gimbals used the same interference board and it can be installed inside the shell.

    You can also install the iOSD module inside if you have one.
    IMG_5551.jpg