gimbal not working

Hi all, I'm opening this thread as a few weeks ago my phantom 3 standard fell from about 5mt high damaging the Y motor, lower board and landing skids. Black ribbon cable and main gimbal power terminal block (white connector) in very good condition. I purchased and replaced the above damaged...

I flew my P3P during the eclipse 8-21-2017, everything worked as designed. I returned it to its hard case, got it out to fly mid September and the problems below occurred. The problems I am having. 1. Micro SD Card reader is not operating. 2. The camera or gimbal isn’t working. 3. When I...

Really appreciated if someone could help: - 1.flight out of the box was fine, forced me to do RC update and then I did aircraft update also - now I can't connect as dji app go says "aircraft disconnected" and under setting "gimbal disconnected" Almost tried everything - nothing helped -...

So I think I got really lucky but still have not resolved my problem (but it happened last night) I was flying my drone and it was about 300 ft up when all of a sudden it started to spin out of control. There was nothing I could do but to jump in my car and chase down where it landed. To my...

Hi all I have the phantom 3 advanced and have had it for about 5 months now and its been working great. after a small crash though the camera gimbal is pointed slightly to the left. I have already tried an IMU calibration followed by the standard camera calibration but it didnt help. this is my...

I crashed my P3. the ribbon and gimbal arm broke fixed it with new arm and new ribbon. now the camera and gimbal do not move. when turning the machine on it dose not do anything. any help will be awesome. do I need to send it off?

So i Crashed my phantom 3 and replaced all the broken parts. The internals looked pretty good, replaced all cables including the ribbon cable, now when I turn on my p3 the gimbal and camera do absolutely nothing. Took everything apart again and made sure all connections were tight, screws were...

This is the problem i have after a crash. Changed ribbon cable and circuit boards (the 2 small). I'm running out of ideas. Anyone can help? Video of the issue.

Today I had two normal short flights with my P3P. And then move (by car) few kilometers to the new position. I calibrated the compass. But the app said there is a strong interference and should be moved to other position. So I moved 20m away and try again to calibrate it. It was successful (at...