calibrarion

How often does the compass need to be calibrated? I'm a new pilot. I've flown my P4P only about four times. Flights have taken off in different locations around an area of about 10 square miles. But Go4 app has never requested a compass calibration; not even the first time. I'm just scared...

Hi. Last week I was shooting some videos. When I look down about 45 degree there was happen some shaking vibrating. 4 files were trash cause of this. I couldn't use it on my short film. There was about 5knot wind speed. One of other problem is when I set a frame it did some little pan itself...

I just got my P3 from Best Buy yesterday and have only flown it once. The first time I flew it I didn't calibrate it and now this time my drone won't take off unless I do calibrate it. When I calibrate it horizontally it works but when I do it vertically it says I'm too close to something metal...

Yesterday I try to fly P3 A with about 40% battery, good weather no winds. The Phantom took off OK from a parking roof top and within couple of minutes at about 50 ft away and 15 ft up, it became wobbly and drifting few feet randomly and quickly. The warning on remote was something like...

I'm trying to determine if this dreaded mid air compass errors are just for DJI GO app. I would like to hear from users using Litchi app. I may as well switch to Litchi if there are no issues with compass errors. That seems to be a cheaper and safer alternative solution than dealing with DJI...

I have the IMU initialization error. I have set the P3 pro on level ground, and waited for it to initialize for 30 minutes, but it never does. I have turned the controller and app on 1st and opened up the IMU sensor panel. Then, turned on the drone, then hit IMU calibration, but nothing happens...

Hello everybody Let me start by saying I have searched this forum for a solution for this problem but haven't found anything. I bought a Phantom 3 Pro and flew it for a few days without any errors, before I had the opportunity to update the firmware. After the firmware update I encountered a...