There's been many reports including mine that the ipad mini 2 when used on the Inspire 1, FPV video starts freezing intermittently when it get's warm. Would turning Hardware Decode off take care of this issue?
Thanks for the link. I have read that info a few times. It doesn't really describe my situation. However, It could infer it but I have still not mastered the Chinese interpretation of the English language. o_O
Hi Guys,
I'm having this problem on my P2. I'm running the latest software/firmware as of 6/5/2015. My Gains are default in Naza Mode.
When I am letting the Phantom hold a hover in GPS Mode, it will occasionally Yaw about 10 degrees in One direction or the other. It will Yaw and immediately go...
Yep, I checked my Props and only 2 needed a bit of Balancing (Dynamically Balanced) Motors are Vibration free. Gimbal is balanced for ND filter being on. Dropped Basic Pitch and Roll Gains from 125 to 120. Dropped ATTI Pitch and Roll Gains from 240 to 220 (Much nicer for filming !) all those...
I've got some minor vibrations on my P2/Zen H3-3D (White Balls) running the latest FW. 3.14. I've got the Hero 4 Black with a 5.4mm lens. I'm also using a 2 stop ND filter and shooting 4K 24/fps. The Default Gains which I am running seem to be lower than previous FW/SW versions. Anyone adjust...
No Wind. It does it every time with or without wind. It has been doing this with past FW's also. Where is the Barometer located? I'm guessing inside the FC.
On my P2 with Zen H3-3D running FW 3.14 SW 3.08, I am finding that at an Altitude of 8 feet or less the copter does not want to maintain Altitude. In GPS Mode and hovering at an Altitude of around 8 feet, it starts descending and doesn't try to maintain Altitude. I can apply some throttle and...
Been a while since I've posted here but I've got a question.
I have the Phantom 2 (original version) with Zenmuse H3-3D Gimbal.
I wanted to upgrade the compass to the newer Ant-Static (enclosed) version. I saw 2 versions. Part # 16 (Phantom 2/ Phantom 2 Vision) and Part # 18 ( Phantom 2 Vision...
I've never seen the option in the Phantom Assistant Software to change the Gimbal Frequency. I know you can in the Zenmuse Software but that doesn't work with the Phantom.
I also had a strange high pitched squeal sound on the GoPro Audio from one of my H3-3D Gimbals. It was on another craft...
I had a 1 month old Black Pearl RC801 FPV Monitor which kept draining the battery after 20 minutes. Replacement battery did the same thing.
The store replaced the unit with another one. I noticed the new one is a different model. It's a FPV58100.
They appear to be identical. What is the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.