Recent content by XLoader

  1. X

    Software Assistant for Phantom 1

    Well after two years of flying this Phantom 1.1.1 I finally managed to get the IOC to stay checked. I have always set the phantom on my metal top desk to run the assistant and always the IOC box would not stay checked. I could leave and come back to it and it would be unchecked. Today I set the...
  2. X

    Phantom 1.1.1 start up light sequence

    At start when it goes through the light sequence and starts the rapid green flashing, I though it was ready to fly but then after a couple more blinks, it will go through the rapid flashing again. So it does the rapid flashing twice. Is something wrong? It seems to perform just fine, flies great..
  3. X

    Software Assistant for Phantom 1

    I did the IMU calibration. I did the compass dance. The IOC box still does not stay checked. The mesage still pops up that the GPS is not calibrated or has magnetic field interference. I know that the HOME LOCk must be on because it will come home when I switch to HL and pull right toggle back...
  4. X

    Software Assistant for Phantom 1

    I did exactly what you suggested. Unplugged from USB and went out in the yard and did the Compass Calibration. Went back in and plugged up to computer and still in the IOC page the box will not stay checked. I also get a message saying the GPS is not calibrated or magnetic interference. What...
  5. X

    Software Assistant for Phantom 1

    Thanks IflyinWY That ENTER key may have been the answer. Now most of the changes are saved except the IOC checkbox there for Home Lock on upper left does not save. Maybe I just have to check the box then leave and not come back to it. I just click the exit on software then disconnect power to...
  6. X

    Software Assistant for Phantom 1

    I am new to the Phantom forum. Can anyone give me some clues as to how to use the software assistant? I get hooked to usb, power is on the controller and Phantom. When I change a value on a page and leave the page and return, it will go back to default. I don't know if the new values got...