Recent content by wxviewer007

Excellent! Thank you for your input! We'll see what we can dig up to make that work! Bob

Hi fellow pilots! I'm interested in attaching a payload via a 3D printed board that will be removable and attached to the stock vertical legs on the back side of the 2+ (Behind the camera). I would like to link to this payload while in flight and was wondering if anyone has tried or has...

Update....The Tablet I used....Samsung Galaxy Tab 4 10.1......SUCKS! Video was pixelated(sp?) and laggy. Hell the app was laggy. I dont blame the app I blame the tablet....DO NOT USE THIS TABLET for FLYING!!

I wanted the DJI Vision app on my Samsung Galaxy Tab 4 10.1. Figured it out. Got ahold of the apk file and installed it manually. Thanks for checking in tho!

What app did you use? I cannot load the DJI Vision App as it says its for phones only.

Okay I had a feeling it was something along those lines. Thanks for the video too! Bob

Hello? Am I invisible?

MM53. What is the black thing on the upper right landing strut in the bottom picture?

Also does anyone know what it means when the gimble motherboard LED that faces front is yellow?

Yes heat sinks directly attached to wifi module.

Hi Frank. I'll probably be doing the same thing in the near future!

Yes I went with the original mod and took a step further by adding the aluminum heat sinks to the Wi-Fi module itself.

Absolutely yes! On top of the Wi-Fi module it fits inside the shell and does not touch the GPS under the top. We are going to add these on today. Here are the heat sinks before application.

Quick check... Version 3 ....Copper Tape mod necessary? I'm also going to go with a bigger GPS antenna. Thanks in advance!! New to the hobby! :-) Bob

A Couple of questions. 1st...I have a V.3 wifi that is toast. I'm going to do the Arctic Silver thermal compound on all of the chips from the first page on another V.3 wifi module that has not yet failed. Additionally, I found these perfectly sized aluminum heat sinks(1st picture) I plan on...